It refuses or stops a charge
The charging point, cable, inlet, controls and onboard equipment need separating. Tell us whether AC charging, DC charging or both are affected.
Independent BYD care in Al Quoz
Your BYD is plugged in, but it won’t charge. Or it drives, yet the AC, brakes or suspension don’t feel right. Tell us what changed. We’ll assess the problem, explain the repair options and give you an itemized quote before work starts.
Start with your BYD model and the concern. We’ll help you arrange the first checks and explain any specialist work needed.

Start with what the car does
You don’t need to diagnose it before calling. Whether the car wakes up, enters drive and accepts a charge gives us a useful starting point.
The charging point, cable, inlet, controls and onboard equipment need separating. Tell us whether AC charging, DC charging or both are affected.
A charged traction battery does not rule out a low-voltage supply problem. We assess the relevant supply, connections and warnings before deciding which component needs work.
Weak cabin cooling, knocking, pulling and brake noise deserve their own checks. An EV still has wear items. Replacing the largest assembly first can be an expensive guess.
Price the actual work
These are workshop estimate ranges in AED including 5% VAT for compatible applications. The quote confirms your BYD’s parts, included labor and any extra procedures.
| Work and included items | AED with VAT |
|---|---|
| Scan and initial fault checksAn agreed scan and first checks of the reported fault. Extended EV testing, battery-capacity testing, dismantling and specialist support are separate. | 150–350 |
| Standard brake padsOne axle, a compatible new quality aftermarket pad set and fitting. Higher-cost applications may be 300–1,500. Sensors and additional hardware are separate. | 250–500 |
| Conventional pads and discsTwo new quality aftermarket discs, one pad set and fitting on one axle. Caliper repairs, extra sensors and specialist brake equipment cost more. | 650–2,500 |
| Brake fluid replacementSpecified fluid, routine replacement and bleeding. Hydraulic faults or unusually complex procedures are quoted separately. | 150–350 |
| Repairable tire punctureOne tire, internal inspection and a suitable tread repair. Sidewall damage or damage from running flat requires a replacement assessment. | 50–120 |
| Four-wheel alignmentMeasurements and the adjustments the car permits. Repairs, seized adjusters, balancing and required steering-angle or ADAS calibration are separate. | 200–350 |
| Work and included items | AED with VAT |
|---|---|
| Four-wheel balancingFour standard wheel-and-tire assemblies, labor and weights. Larger or specialist fitments need a specific quote. A single wheel is 40–80. | 120–240 |
| Bushing or anti-roll bar linkOne straightforward component replacement with a new compatible part and fitting. Complex pressed bushings, alignment and other worn parts are separate. | 150–600 |
| Control arm or ball jointOne confirmed worn arm or joint, a compatible new aftermarket part and fitting. Some joints require the complete arm. Alignment is separate. | 400–1,500 |
| Conventional shocks or strutsA compatible pair of new conventional shocks for one axle, installed with routine alignment where needed. Mounts, springs, seized hardware and adaptive suspension need a separate estimate. | 1,000–3,200 |
| ABS wheel speed sensorOne compatible sensor, fitting and fault verification. Wiring, wheel-bearing assemblies, control units and additional investigation are separate. | 350–1,200 |
| Engine oil and filterFor PHEV or gasoline engines only. Specified oil, a compatible new filter, labor and checks. Typically 200–350 for up to 5 liters. Higher capacity or a costlier approval can be 350–600. | 200–600 |
Traction batteries, lithium low-voltage batteries, onboard chargers, inverters and electric AC compressors vary too much to price from the badge alone. Identify the failed part first. The complete estimate should include removal, fitting, fluids, required setup, testing and VAT.
Where both services are needed, our standard four-wheel alignment and balancing combination is AED 320–550 including VAT. Specialist fitments and calibration are separate. Genuine parts, unusual access and additional faults can change any estimate above. Diagnosis is separate unless expressly included.
The charging session tells a story
A failed session is frustrating. It also leaves clues. Keep the exact message and note where the attempt happened, rather than clearing the warning before it can be checked.
We assess the vehicle complaint and agree further tests when needed. Fixed building wiring and charging-station supply faults belong with the charging provider or a qualified electrician.
Check the session message, schedule and charge limit shown by the car. The charging equipment or supply may be involved. Share any comparison you already have. Don’t keep retrying damaged equipment.
The onboard charger is part of the AC charging path. DC charging uses a different path. This distinction helps choose the next tests. It does not prove that one named part has failed.
Inspect the inlet, latch and relevant controls using the correct procedure. Do not force the plug or alter the connector. A stuck latch and damaged power terminals are different repairs.
Charge level, temperature and charger output can affect speed. A persistent change under comparable conditions needs assessment of the warnings and thermal system, not an automatic battery replacement.
Match the car before the service
BYD makes fully electric vehicles, plug-in hybrids and older gasoline models. A service menu needs to recognize that difference.

Priorities include charging operation, available battery-system data, cooling, low-voltage supply, brakes, tires and suspension. Filters, fluids and reduction-drive servicing follow the exact schedule. DOLPHIN and other imports need their own model and market check.
These combine electric driving with a gasoline engine. Oil, filters, ignition and engine-cooling requirements remain relevant even when many trips use electric power. Newer DM-i models, including SEAL 7, need the correct year-specific procedure.
Start with the engine, transmission and available parts for the actual car. Conventional starting, cooling and oil-leak repairs belong here. We confirm supply and the required work before promising a completion date.
Two batteries two different questions
“Battery replacement” can mean a small auxiliary supply or the high-voltage traction pack. The price, equipment and repair decision are completely different.
The low-voltage battery supplies control systems. Its condition, connections and charging support need checking when the car is unresponsive or repeatedly loses power.
The replacement must match the vehicle. Any required setup and further testing belong in the quote.
BYD’s Blade Battery uses lithium iron phosphate chemistry, commonly called LFP. That does not mean every BYD pack has the same construction or can be repaired in the same way.
Available fault data, temperature readings, cooling condition and physical damage guide the assessment. Internal work is considered only where the specific repair method, compatible parts and qualified support are available.
For a possible manufacturer claim, check eligibility before authorizing paid internal work. We’re an independent workshop, not a BYD-authorized dealer.
State of charge tells you how much charge is available now. It is not a measure of the pack’s remaining life.
A BMS state-of-health value is information from the battery management system. Ask what data is accessible and how the result was obtained.
A serviceable component repair may be possible. Extensive damage or an unsupported internal repair can require a complete compatible assembly.
A dashboard range estimate is not a controlled capacity test. For a used BYD, agree the battery and charging checks included in the pre-purchase inspection. No single reading guarantees future battery life.
Cooling and maintenance
Tell us if warm air comes with a charging restriction, coolant warning or unusual noise. Those details change what needs checking.
A blocked cabin filter or blower fault can reduce airflow. Refrigerant loss, compressor control or thermal-system faults need different tests.
Electric compressor systems require the specified oil and suitable handling. A universal refrigerant refill package is not a complete AC repair plan for every BYD.
A SONG PLUS DM-i used mostly in electric mode still has an engine. Follow the correct time and mileage schedule for oil, filters and other due items.
A pure EV needs a different checklist. Our oil and filter service applies only where an engine is fitted.
Previous repair details can helpIt shows what was actually replaced, which fluid was used and what was only recommended. That helps avoid paying twice for the same service.
The parts between you and the road
Electric drive makes some road noises easier to notice. A hum or knock still needs locating before it is blamed on the motor.

Inspect tire condition, pressures, joints, bushings, mounts and bearings. An alignment cannot remove play from a worn component, and balancing cannot repair a damaged wheel.
Choose tires by the required size, load and speed ratings, plus the intended use. An EV label alone does not establish compatibility. See our fitted tire options and alignment and balancing inclusions.
After relevant suspension or geometry work, check whether steering-angle setup or driver-assistance calibration is required. Confirm it in the complete quote.

Friction brakes still have pads, discs, calipers and fluid. Measure wear and inspect operation before choosing pads alone or a complete axle repair.
A changed pedal, pulling or reduced stopping ability needs prompt assessment. A brake warning should not be dismissed as normal regenerative braking. Our brake repair options explain the work included.
Use the model’s service procedure for electronic parking-brake and hydraulic work. Fluid replacement and a brake-control fault are different jobs.
See how a quote comes together
Use these estimated scenarios to compare the scope and total of a possible repair. Each assumes the stated vehicle condition and compatible parts. They are not completed customer jobs.
Typical job estimate
2023 BYD ATTO 3The tires and suspension are serviceable. Measurements justify alignment, and wheel imbalance also needs correcting.
Four-wheel measurement, available adjustments, balancing of four standard assemblies, weights and checks. Tires, repairs and extra calibration are separate.
320–550
AED including 5% VATTypical job estimate
2024 BYD SEALInspection confirms that conventional front pads and both discs need replacement. No caliper or hydraulic fault is included in this example.
Two compatible new quality aftermarket discs, one pad set and fitting. Genuine parts, unusual brake specifications and additional hardware change the quote.
650–2,500
AED including 5% VATTypical job estimate
2024 BYD SONG PLUS DM-iThe schedule and service history confirm that both items are due. This is an itemized maintenance example, not a full-service package.
Engine oil and filter: AED 200–600. Routine brake fluid replacement: AED 150–350. Other due items are listed separately.
350–950
AED including 5% VATThe written quote identifies parts, quantities, included labor, any separate diagnosis and the applicable parts and workmanship terms. It also confirms stock and expected completion before you approve the work.
Your BYD visit in Al Quoz
My Car Repair Dubai operates from AMF AUTO SERVICES LLC in Al Quoz. We combine relevant scan information with physical inspection. The first useful outcome is a clear explanation of the fault and the next approved step.
Routine wear parts may have suitable genuine or identified aftermarket choices. High-voltage components need exact compatibility and a supported procedure. A low price for the wrong part is not a saving.
Imported BYDs can differ in charging connections, software and parts. Start with the model and problem. We can check the VIN and market specification during assessment, explain any access limits and identify work that needs an authorized provider.
Monday to Friday 5 AM to 10 PM. Saturday 5 AM to 6 PM. Closed Sunday.
Get directions to the workshop
Call 050 608 7150
Pickup and drop-off can be arranged. We confirm availability, access and any collection charge with you.
Describe the concern and confirm the initial charge. Additional investigation or dismantling needs another agreement.
Review the diagnosis, part identity, new or reconditioned condition where offered, fitting, fluids, setup, tests and VAT. Any reconditioned assembly needs a clear account of its condition and work performed.
Check supply lead time, expected completion and the specific warranty terms and exclusions. Approval comes before repair.
Handover should explain the completed work, remaining recommendations and applicable test results. Keep the invoice with the vehicle’s service history.
Before you book
Answers about BYD repair prices, charging concerns, imported models and visiting our Al Quoz workshop.
The agreed scan and initial fault checks are estimated at AED 150–350 including VAT. Routine prices depend on the work: four-wheel alignment is 200–350, while an engine oil and filter service is 200–600 for applicable hybrid or gasoline models. A battery-electric BYD does not need an engine oil service. Battery-pack, charging-unit and high-voltage work need a separate estimate.
The initial visual assessment of accessible areas is free. A scan, electrical investigation or further testing is agreed separately. Confirm the first-stage charge before leaving the car. A visual check is not a battery-capacity certificate.
Tell us your BYD model and what happens when you connect it. If you already know whether the problem affects home AC charging, public DC charging or both, include that detail. A warning photo can help. Do not force a stuck connector, use damaged equipment or continue charging against a stop warning.
No. The warning must be connected to a confirmed fault. Low-voltage supply, charging hardware, cooling and high-voltage components need different checks. A normal dashboard range estimate cannot clear an active battery warning, and a scan code alone cannot price a complete pack replacement.
We first identify the fitted battery, required procedure and the reason it failed. BYD applications can differ in low-voltage battery technology, so a conventional lead-acid price should not be applied to a lithium unit. The quote confirms the compatible battery, fitting, setup and any further electrical work.
Use the schedule for your model year and original market. BYD UAE currently describes an initial EV service at one year or 20,000 km and typical PHEV servicing at one year or 10,000 km, whichever comes first. Those general figures do not replace your vehicle’s maintenance booklet or a specific repair recommendation.
Yes, you can ask us about an imported BYD. Tell us the model and the concern to start. We check the VIN, original market and required parts or software when relevant. Charging connections and manufacturer access differ between vehicles. We explain any work that needs an authorized provider before a repair is agreed.
Availability depends on the model, market and supported software access. Describe the screen or app problem before booking. Some account, region or manufacturer functions need the authorized provider. We do not promise that a software update can repair failed hardware or change charging compatibility.
We discuss the exact fault and confirm the required diagnostic access, qualified support, repair method and parts before accepting high-voltage work. Internal pack repair is not suitable for every design or failure. An agreed assessment comes before choosing component repair or assembly replacement.
Routine work can often be planned once the parts and appointment are confirmed. Intermittent charging problems, controlled testing and imported components take longer. We agree a realistic completion estimate after the first assessment and update it if additional approved work is needed.
The written quote should state the parts and workmanship terms for the selected repair. For a possible manufacturer claim, check eligibility with the responsible provider before approving paid work. Pickup and drop-off depend on location, access and availability, with charges confirmed first. An unsafe or immobilized car needs suitable recovery.
Our workshop is at 39, Al Quoz Industrial Area 4, Dubai. Monday to Friday 5 AM to 10 PM. Saturday 5 AM to 6 PM. Closed Sunday. Call 050 608 7150 to arrange a visit. Pickup and drop-off are subject to availability, with any transport charge agreed in advance.
The linked ATTO 3 handbook is for the Australian-market 2022 version. Use the correct handbook and warranty documents for your own model, year and market.
Arrange the right first checks
Call or WhatsApp your BYD model and the problem. We’ll help arrange a visit to Al Quoz. A warning photo or a note about charging is useful if you already have one.
Free initial visual assessment. Paid testing agreed before work.
If the car is immobilized, damaged or showing a stop warning, say so first. Recovery must follow the model’s transport instructions.